Diesel Department

MILW 33C and BN 9908

Typical rust along the nose

On Sunday, November 20, we moved the BN 9908, an E9Am, deep into the shop to begin some steel work around the cab and continue interior prep, prime and paint of the floor. Jim West has spent the summer working on sealing up some of the water leaks around the carbody and engine room, and needle chipping, sanding and cleaning the engine room floors, under the cab, and in the nose. It is all primed and is about ready for paint, but needs the heated shop to complete it.

E units are pretty close to F units in where they rust and rot around the nose and sides of the cab. Our plan is to spend one month doing as much steel work as we can before other projects will need the same space in the shop and 9908 will have to be moved out. Back in 2006 we were able to do all the same steel work on the CNW 411 in about five weeks. That story is available here in a photo album. After the work is done on the 9908, it will be painted back to its existing green and black scheme for the short term. Sometime in the future, it will be restored back to CB&Q 9976 with stainless steel side panels and will be used as backup power for the Nebraska Zephyr.

Typical rust holes along the engineer side

cutting and grinding completed and ready for new steel

Some of the typical places of rust and rot are around the lower base of the nose steel against the anti-climber, and where the sheets were welded together along the beams of the cab side, and all around the nose door. Also around the sand fillers and step wells on both sides. We are starting around the anti-climber and nose door and will work our way backwards as these areas are completed. There are many more photos available than are shown in this blog, and are shown here with the most recent being shown first. This photo album will more than likely be updated more often than the blog, but we'll do our best to keep both up to date.