Comments
How do they keep the wall sections vertical before the roof trusses are attached? It would seem that there should be a lot of torque on those two bolts at the bottom of each vertical column. I don't see any temporary bracing being employed?
#1 c kronenwetter on 2015-08-20 22:31
Hello Mr K. I didn't mention that when first installed each column was also secured with a nail into each side. There is no bracing other than they did install the western wall. I didn't take a picture of that yet. Suffice it say very good engineering and level installation practices! You will see from todays post that the roof trusses are being installed and should be completed by Thursday. Roger
#1.1 Roger Kramer on 2015-08-21 04:04
Hello Mr K. I didn't mention that when first installed each column was also secured with a nail into each side. There is no bracing other than they did install the western wall. I didn't take a picture of that yet. Suffice it say very good engineering and level installation practices! You will see from todays post that the roof trusses are being installed and should be completed by Thursday. Roger
#1.2 Roger Kramer on 2015-08-21 04:04
Add Comment

E-Mail addresses will not be displayed and will only be used for E-Mail notifications

To prevent automated Bots from commentspamming, please enter the string you see in the image below in the appropriate input box. Your comment will only be submitted if the strings match. Please ensure that your browser supports and accepts cookies, or your comment cannot be verified correctly.
CAPTCHA

 
Submitted comments will be subject to moderation before being displayed.