| BLOG | DIRECTIONS | SCHEDULE | STORE |
Thursday, November 15. 2012
Find us on Facebook
Fri, 05-27-2016 22:57
A job nicely done Nigel. Thanks to all of the steam team from we watchers out here in Internet land.
Fri, 05-27-2016 15:56
Nigel, That is one big sukker of a turntable! i have pushed a narrow gauge table by hand; i do not think you can do that with the new one [...]
Fri, 05-27-2016 13:39
Can someone contact me via email concerning the smaller turntable, which, I'm told is 80 feet long? Thanks, Bob Yarger Wilton, NY
Fri, 05-27-2016 07:32
Hello Ethan BTW the turntable was successfully unloaded yesterday! Mark Secco and his crew did a marvelous job planning and then executing this [...]
Thu, 05-26-2016 20:32
Hi Roger, Good job on the turntable turntable update. When will 1630 be running? Sincerely, Ethan A.
Its Here, Its big, Its long, Its needs lots of $about
Tue, 05-24-2016 13:10
the smaller one too?
Mon, 05-23-2016 19:52
Hi Raphael We will install the turntable. That is what we will do with it. Thanks Roger
Mon, 05-23-2016 19:51
Yes it will! Needs lots of money, energy and commitment ! Thanks Roger
Mon, 05-23-2016 19:49
Hello Kirk We are starting on the 2524 asap. The 2612 is all but finished. Still to be completed are projects that can not be accomplished by my [...]
Mon, 05-23-2016 14:04
Did you say roundhouse to? That will really be impressive.
Mon, 05-23-2016 13:55
Are you going to finish the 2612 before you start on the 2524r are they both going to be worked on at the same time?
Mon, 05-23-2016 13:04
If you would like to see the turntable frame being moved, go to the IRM main page, click on "webcam information", on the next page click on "webcam [...]