How do they keep the wall sections vertical before the roof trusses are attached? It would seem that there should be a lot of torque on those two bolts at the bottom of each vertical column. I don't see any temporary bracing being employed?
Hello Mr K. I didn't mention that when first installed each column was also secured with a nail into each side. There is no bracing other than they did install the western wall. I didn't take a picture of that yet. Suffice it say very good engineering and level installation practices! You will see from todays post that the roof trusses are being installed and should be completed by Thursday. Roger
Hello Mr K. I didn't mention that when first installed each column was also secured with a nail into each side. There is no bracing other than they did install the western wall. I didn't take a picture of that yet. Suffice it say very good engineering and level installation practices! You will see from todays post that the roof trusses are being installed and should be completed by Thursday. Roger