Diesel Department

More rust removal on the left and welding back together on the right.

On Tuesday night, Kyle M worked to remove some additional rot spots on the engineers side of the nose. This takes some time since there are a few layers of steel skin and angle iron supports to cut through, and not hit anything behind it all. Meanwhile I started to weld some new steel supports around the firemans side nose, along with adding some support to the side of the mount for the cab signal box. A new sheet has been cut to wrap around that side, and will be fitted and installed in the coming days. There are many more photos available than are shown in this blog, and are shown here with the most recent being shown first. This photo album will more than likely be updated more often than the blog, but we'll do our best to keep both up to date.

More rot removed from the engineers side of the nose.

We chose to use smaller sections of thicker angle instead of a continuous piece around the curve of the nose.

MILW 33C and BN 9908

Typical rust along the nose

On Sunday, November 20, we moved the BN 9908, an E9Am, deep into the shop to begin some steel work around the cab and continue interior prep, prime and paint of the floor. Jim West has spent the summer working on sealing up some of the water leaks around the carbody and engine room, and needle chipping, sanding and cleaning the engine room floors, under the cab, and in the nose. It is all primed and is about ready for paint, but needs the heated shop to complete it.

E units are pretty close to F units in where they rust and rot around the nose and sides of the cab. Our plan is to spend one month doing as much steel work as we can before other projects will need the same space in the shop and 9908 will have to be moved out. Back in 2006 we were able to do all the same steel work on the CNW 411 in about five weeks. That story is available here in a photo album. After the work is done on the 9908, it will be painted back to its existing green and black scheme for the short term. Sometime in the future, it will be restored back to CB&Q 9976 with stainless steel side panels and will be used as backup power for the Nebraska Zephyr.

Typical rust holes along the engineer side

cutting and grinding completed and ready for new steel

Some of the typical places of rust and rot are around the lower base of the nose steel against the anti-climber, and where the sheets were welded together along the beams of the cab side, and all around the nose door. Also around the sand fillers and step wells on both sides. We are starting around the anti-climber and nose door and will work our way backwards as these areas are completed. There are many more photos available than are shown in this blog, and are shown here with the most recent being shown first. This photo album will more than likely be updated more often than the blog, but we'll do our best to keep both up to date.

Old filter housings

New filter housing

On the evening of November 18th, Jeron G, Riley L and myself installed a used primary fuel filter housing in GB&W 2407. We decided to standardize on a common element on several locomotives to reduce costs for stocking several styles of fuel filter elements and eliminating the really expensive ones. We removed the two housings and the fuel lines going to them, cut and welded some brackets to hold the new housing in a good angle to be able to change elements without hitting other parts in the engine room. All that remains is replacing the fuel lines to the filter housing. Afterwards, Jeron and Riley moved on to an oil leak on the oil strainer housing, making and replacing a couple of gaskets.

Be sure to visit this album for photos of other recent shop work. Also, donations to the RSD15 are still needed to replace cab glass and repair the turbocharger.